611 visninger
|
Oprettet:
manual. hvor {{forumTopicSubject}}
hejsa
jeg har denne sender/modtager FlySky FS-GT2 2.4G, men har fundet ud af at dens failsafe er sat til at gasse op istedet for at bremse. det vil jeg gerne have lavet om, men jeg har ikke nogen manual og jeg ved ikke hvordan man indstiller failsafe.
håber i kan hjælpe mig
okt 2010
Følger: 4 Følgere: 3 RC-enheder: 1 Emner: 8 Svar: 472
okt 2010
Følger: 4 Følgere: 3 RC-enheder: 1 Emner: 8 Svar: 472
sep 2010
Følger: 3 Følgere: 2 RC-enheder: 1 Emner: 30 Svar: 152
sep 2010
Følger: 3 Følgere: 2 RC-enheder: 1 Emner: 30 Svar: 152
okt 2010
Følger: 4 Følgere: 3 RC-enheder: 1 Emner: 8 Svar: 472
How to bind the RX (receiver) to the TX (transmitter):
1. Plug bind plug into CH3, turn on car, the LED light should flash
2. Hold down bind button on transmitter module while turning on the TX
3. The light should go steady now
4. Let go of bind button, turn off car, remove bind plug, turn off TX
5. Turn on TX and then turn on car, it should be bound now
To set the fail-safe:
(Please note there is only a fail-safe for channel 2. 1 & 3 do not have fail-safe)
1. Turn on both RX and TX
2. Hold the throttle (CH2) in the position you want it to be in when fail-safe kicks in (example: brake position). Alternatively, you can use your throttle trim to put the throttle in brake mode, instead of holding down the trigger, it’s easier.
3. Press the fail-safe button until it blinks and turns solid again.
4. Test it! Go full throttle and turn the radio off. It should go to brake position.
(Kilde: http://kenbuys.com/flysky-fs-gt2/ )
sep 2010
Følger: 3 Følgere: 2 RC-enheder: 1 Emner: 30 Svar: 152
okt 2010
Følger: 4 Følgere: 3 RC-enheder: 1 Emner: 8 Svar: 472
manual. hvor